First, understand why the Gravity Teapot pours at all
The Gravity Teapot does not have a tap or a spout you tip. It uses a gravity-flow filter: place the pot on your mug or cup, and tea flows down through the filter. Lift the pot, and the flow stops automatically.
That design is why a drip is usually a seating problem rather than a broken seal. The pot only releases liquid when it is resting on a cup, so anything that interferes with that resting position can let tea escape when you do not expect it.
What the Gravity Teapot is made of
- Gravity Teapot (SCHOTT Duran® Glass): The teapot is made of lab-grade SCHOTT Duran® borosilicate glass from Germany, with a stainless steel mesh filter. The glass body and metal filter are the two parts that meet your cup. Knowing the materials helps you check the base and filter without guessing.

Gravity Teapot (SCHOTT Duran® Glass) - Gravity Teapot (SCHOTT Duran® Glass): The capacity is 500ml, and the size is 10 cm x 13 cm. A 500ml pot is heavy when full. The base needs to sit flat and centred on a cup wide enough to support it.
Checks that fix most gravity teapot drips
Work through these in order. Each one tests a different part of the gravity-flow path.
- Check that the cup rim is flat and wide enough: A mug with a thick, rounded or uneven rim can stop the base from sitting flush. Try a cup with a flat rim and a diameter that comfortably supports the 10 cm base.
- Centre the pot on the cup: If the pot is off-centre, one side of the base may lift slightly and let tea seep past the filter area. Set it down squarely before you rely on the flow stopping.
- Look at the stainless steel mesh filter: The filter is the part that holds the tea back. Check that it is seated correctly and free of loose leaves caught around its edge. The supplied information does not describe a replaceable seal, so do not force or dismantle the filter.
- Do not touch the underside during brewing: The manufacturer explicitly says never to touch the underside of the teapot during brewing. Handling the base while tea is inside can disturb how it sits and is a safety risk with hot liquid.
- Lift the pot fully to stop the flow: The flow stops when the pot is lifted. If you only tilt or partly lift it, tea can continue to run. Lift it clear of the cup and set it down on a stable surface.
- Wash by hand and dry the base: The manufacturer recommends hand washing. Residue or moisture on the base can affect how the pot seats on the cup, so dry it before the next brew.
When the drip is not a seating problem
If the pot still drips after you have checked the cup, the centring and the filter, the supplied information does not identify a specific cause or a repair procedure. In that case, stop using the pot with hot liquid and contact Tavalon Tea Australia for advice rather than attempting a fix that is not documented.
Be cautious with any advice that tells you to add a seal, tighten a part or use a tool on the filter. The supplied record describes a gravity-flow filter and a stainless steel mesh, but it does not describe a user-serviceable seal or replacement part.
Care habits that keep the flow predictable
Hand washing is the stated care method. Avoid sudden temperature changes even though the glass is described as resistant to thermal shock, and never handle the underside during brewing. Store the pot without weight on the filter, and check the mesh for trapped leaves before each use.
A little attention to how the pot meets the cup is the most reliable gravity teapot troubleshooting you can do. The Gravity Teapot is designed to stop the flow when lifted, so a persistent drip is a signal to check the seating and the filter before you brew again.


